default

Antenna boosters focus signal direction, increasing strength by up to 100x (20dB), while amplifiers boost power directly, enhancing signal strength by up to 1000x (70dB). Antenna Booster Antenna gainers enhance signal strength by optimizing the reception performance of the antenna, which uses high-gain antennas or reflectors to focus the signal in a specific direction, thereby […]

The waveguide horn antenna is a directional antenna extended from a waveguide. Common models include X-band (8.2-12.4GHz), with a gain of 10-20dBi. The radiation efficiency is optimized by adjusting the horn angle and length, and it is widely used in radar and satellite communication systems. Basic Definition Microwave engineers know waveguide horn antennas are the

The impedance of a rectangular waveguide wave varies by mode. For the common TE10 mode at 10 GHz, if the waveguide’s wide side is 2.286 cm, the characteristic impedance is approximately 377 ohms, calculated using the formula 𝑍=𝜂1−(𝜆2𝑎)2Z= 1−( 2aλ​ ) 2 ​ η​ where 𝜂η is about 377 ohms. TE mode In the most

Place the antenna booster as close to the antenna as possible to minimize signal loss, ideally within one meter, as signal attenuation occurs at about 3dB per meter of coaxial cable. Near the antenna For the antenna amplifier to work best, it should be placed as close to the antenna as possible. The signal in

The gain of horn antennas is usually less than 20 dBi, with weak directivity, and is suitable for microwave communications and measurements. Its performance is limited by the size of the aperture, and it is difficult to achieve high-precision processing of large antennas, which affects the radiation efficiency and beam control capabilities. Volume Issues Every

The TIA 568 standards include Cat 3, Cat 5e, Cat 6, Cat 6a, Cat 7, Cat 8, Multimode Fiber (MMF), and Singlemode Fiber (SMF), supporting various data transmission speeds and distances. Category 3 (Cat 3) Category 3, also known as Cat 3, is a cable that supports data transmission up to 16 MHz, primarily used

Waveguide to coaxial conversion adapter is used to connect waveguide and coaxial cables. Typical parameters are frequency range 1-18GHz, interface type N-type or SMA. Ensure good matching during operation to reduce reflection loss. It is often used in microwave test equipment. Adapter Definition At 3AM, ESA mission control received ChinaSat 9B alerts – its WR-42

The structural standards for antenna supporting structures require materials to meet ASTM international standards, involve rigorous load testing up to 150% of the design load, and include detailed non-destructive weld inspections. Types and Functions of Antenna Support Structures Lattice towers are used for broadcast television towers and military radar stations, capable of supporting 10-ton antennas

Starlink primarily operates in the Ku-band at 12 to 18 GHz and the Ka-band at 26.5 to 40 GHz, optimizing global internet connectivity. Ku-band Usage In order to provide a secure connection between its orbiting satellites and user terminals on Earth, Starlink uses the Ku-band. Typically, the Ku-band can be defined as a frequency range

Yes, you can clean a waveguide. Use compressed air (30-70 psi) for dry cleaning and 90% isopropyl alcohol for wet cleaning, ensuring complete drying with heat below 40°C. Turn off and disconnect the equipment One should always make sure that the equipment is safely powered off before taking any steps to maintain it. It becames